Instructions for updating the firmware SVEN SPS-830

Attention!!! THE FIRMWARE IS ONLY FOR THE SVEN SPS-830 MODEL, DO NOT USE THE FIRMWARE FOR OTHER SVEN MODELS

To update the firmware, you need to do the following:
1) Write the firmware file "SVEN SPS-830_V2_20250321_USB.MVAX" to a USB flash drive (up to 4Gb). The USB flash must be formatted in FAT32, and the USB flash must contain only the firmware file;
2) Insert the SPS-830 power plug into the wall outlet;
3) Turn on the SPS-830 in any play mode;
4) Insert the USB flash drive with firmware into the USB socket on the back panel;
5) The speaker will automatically switch to USB reader mode. The indicator will turn purple for a while, then the system will switch to standby mode – the indicator will turn red;
6) Remove the USB flash drive from the USB port of the SPS-830;
7) The update is complete.